donderdag 11 september 2014

Tip 4 / Suggestion 4

Hoi hoi,

vanavond zoals beloofd een nieuwe tip ... deze tip gaat over het knippen van 3d plaatjes. Het word tegenwoordig steeds minder gedaan maar voor degenen die het wel nog doen (of willen gaan doen) deze tip :

Soms heb je onderdelen van een 3d plaatje die zo smal zijn dat ze dreigen af te breken als je gaat knippen. Plak op de achterkant een adressticker of een stukje tape en knip daarna het plaatje uit. Op deze manier is het extra stevig.

Ik knip meestal alle 3d plaatjes uit als ik samen met mijn vriend op de bank tv zit te kijken, zo'n dienblad met een kussen eraan vind ik ideaal om hiervoor te gebruiken. Ik berg ze dan op in fotomapjes en als ik een plaatje nodig heb ben ik snel klaar ...







Hi everyone,

this evening, as promissed, a new suggestion ... this suggestion is about cutting 3d images. It's not so much used these days but for the ones that still use 3d images (or want to use them) this suggestion :

Sometimes there are really small pieces on the 3d images, if you're not carefull they easily damage. Take an adress-sticker or a little piece of tape and stick it to te back of the 3d image and then cut out the image. This way it's easy to cut out without any damages.

I usually cut out my 3d images when I'm on the couch with my friend who's looking tv. I use a tray with a cushion attached to it as a laptable. When I'm finished I store the images in those little maps for photo's so when I need an image it only takes a few minutes to put them together ....



Geen opmerkingen:

Een reactie posten

Wat leuk dat je hier een berichtje achterlaat. Bedankt !
Lieve groetjes,
Willeke

Nice of you to leave a reply here. Thanks !
Hugs,
Willeke

Schön dass du mir hier einen nachricht hinterlässt. Vielen Dank !
Liebe grüsse,
Willeke